Surface Prep Equipment
Envirothane E4111 provides extra heavy duty protection for high wear industrial floors. Use as a high build self-levelling epoxy or as an epoxy mortar.
A versatile coating, E4111 is used for extra heavy duty protection for high wear industrial floors and where chemical spillage may occur. Itcan be thinned down to apply as a primer or thickened by adding sand for high build trowel-on applications and forming coves at floor-to-wall junctions.Can be used with anti-slip media to achieve various safety ratings. Low VOC Certification is available for GreenStar Projects.
E4111 has excellent flow properties when used as a self-levelling compound. Add 1 part E4111 to 2 parts Silica 50N sand to build up to the required depth. Add 1 part E4111 to 4-7 parts sand for an epoxy mortar.
|Typical use areas:||Key Features|
|1. Heavy manufacturing plants
2. Schools, hospitals and shopping centres
3. Butcheries and abattoirs
4. Water treatment plants
5. Chemical storage and battery charge areas
6. Steel in extreme environments
7. Factories, warehouses and hangers
8. Workshops and laboratories
9. Truck loading areas and wash bays
|1. Suitable as primer and topcoat
2. For high build applications, patching and coving
3. Extremely durable
4. Suitable for use with anti-slip media
5. Enviro-friendly and Green rated
6. Easy to clean and maintain
7. Compatible with line marking
8. Very Chemical resistant
|Volume Solids: 100% by volume
Mixing Ratio: 2 : 1 (Part A : Part B)
Coverage: 1 – 2 coats, 5-10m2/litre/coat
Abrasion Resistance: Very good abrasion resistance
Chemical Resistance: Very good resistance to most chemicals
Solvent Resistance: Very good
UV Resistance: Chalking will occur during full sunlight exposure without loss of film integrity. Over coat with urethane top coat for UV resistance.
|Equipment: Squegee, spray, airless or air brush or roller
Pot Life: Approx 1 hour @ 200C
Recoat: 16 hours minimum
Dry time: Touch Dry 6 Hours @ 250C (minimum), Tack Dry 18 Hours @ 250C
Full Cure: Light foot traffic 24 hours, full cure 6 days
Theoretical Coverage: 5 – 10m²/litre @ 100 to 200µm DFT (100 – 200µm WFT).
Clean up: Use V105 or V114 thinners for cleanup
Typical Spec: Thin first coat 30% if using E4111, or use E2000 or E2050 thinned 10-15% as a primer, and then the top coat/s, do not thin
|Technical Data Sheet
High Build Heavy Duty Spec
|Material Safety Data Sheet A
Material Safety Data Sheet B