Surface Prep Equipment
Envirothane E2000 creates a beautiful hardwearing polished concrete look at a fraction of the cost and time of the traditional process.
A super clear epoxy, E2000 is a very versatile coating that is excellent for enhancing colours in substrates such as exposed aggregate. Its good penetration into substrates when used as a primer beneath heavy duty coloured topcoats. E2000 is safe and easy to apply, and can be used with anti-slip media to achieve various safety ratings. Low VOC Certification is available for GreenStar Projects.
E2000 is a popular topcoat for flake floors and decorative coloured bases, as it intensifies the colours while also improving the cleanability and protection of the floor. Extra durability for higher traffic areas can be achieved by applying further topcoats.
|Typical use areas:||Key Features|
2. Entrance lobbies
3. Schools, hospitals and shopping centres
4. Food prep areas and canteens
5. Storage areas
6. Workshops and laboratories
7. Seamless flooring
|1. Suitable as primer and topcoat
2. Safe and easy application
3. Extra clear gloss or satin finish
4. Suitable for use with anti-slip media
5. Enviro-friendly and Green rated
6. Easy to clean and maintain
7. Compatible with line marking
8. Chemical resistant
|VOC Content: 26 grams per litre
Volume Solids: 46% by volume
Mixing Ratio: 1 : 1 (Part A : Part B)
Coverage: 2 – 3 coats, 8m2/litre/coat
Abrasion Resistance: Very good abrasion resistance
Chemical Resistance: Very good resistance to most chemicals
Solvent Resistance: Very good
UV Resistance: Chalking will occur during full sunlight exposure without loss of film integrity. Over coat with urethane top coat for UV resistance.
|Equipment: Spray, airless or air brush or roller
Pot Life: Approx 2-3 hours @ 250C
Recoat: 4 – 5 hours
Dry time:Touch Dry 4 -6 Hours @ 250C (minimum),Hard Dry 18 Hours @ 250C
Full Cure: 7 Days
Theoretical Coverage: 8 m²/litre @ 55µm DFT (125µm WFT).
Clean up: Water, mild detergent or methylated spirits, turps
Typical Spec:Thin first coat 10-15% with water and then subsequent coats do not thin
|Technical Data Sheet||Material Safety Data Sheet A
Material Safety Data Sheet B