Surface Prep Equipment
Envirothane E2100 has an attractive satin finish, excellent durability and due to its ease of application it is the most popular choice for workshops and storage areas.
Available in any colour, E2100 is the most popular choice for all medium wear areas. Its good penetration into substrates makes it a commonly used primer beneath heavy duty coloured topcoats. E2100 is safe and easy to apply, and can be used with anti-slip media to achieve various safety ratings. Low VOC Certification is available for GreenStar Projects.
E2100 is also the most economical base for flake floors, and has been used with artistic pigment spreading techniques to produce attractive mottled effects. Extra wear for higher traffic areas can be achieved by applying further topcoats – e.g. car park turning areas.
|Typical use areas:||Key Features|
|1. Car parks and garages
2. Schools, hospitals and shopping centres
3. Food prep areas and canteens
4. Storage areas
5. Factories, warehouses and hangers
6. Workshops and laboratories
7. Waterproofing concrete slabs before floor overlay
8. Seamless flooring
|1. Suitable as primer and topcoat
2. Safe and easy application
3. Satin finish available in any colour
4. Suitable for use with anti-slip media
5. Enviro-friendly and Green rated
6. Easy to clean and maintain
7. Compatible with line marking
8. Chemical resistant
|VOC Content: 15 grams per litre
Volume Solids: 37% by volume
Mixing Ratio: 1 : 1 (Part A : Part B)
Coverage: 2 – 3 coats, 8m2/litre/coat
Abrasion Resistance: Very good abrasion resistance
Chemical Resistance: Very good resistance to most chemicals
Solvent Resistance: Very good
UV Resistance: Chalking will occur during full sunlight exposure without loss of film integrity. Over coat with urethane top coat for UV resistance.
|Equipment: Spray, airless or air brush or roller
Pot Life: Approx 1 hour @ 200C
Recoat: 4 – 5 hours
Dry time: Touch Dry 3 – 5 Hours @ 250C (minimum), Hard Dry 18 Hours @ 250C
Full Cure: 7 Days
Theoretical Coverage: 6 – 10m²/litre @ 40 to 60µm DFT (100 – 170µm WFT).
Clean up: Water, mild detergent or methylated spirits, turps
Typical Spec: Thin first coat 10-15% with water and then subsequent coats do not thin
|Technical Data Sheet||Material Safety Data Sheet A
Material Safety Data Sheet B